Induction Furnaces Division - Prestige Thermal

	Brazing Part: refrigerant charging port steel T joint assembly Process Temp: 760ºC Time to Temp: 6 sec. Notes: use a braze perform with a channel coil to heat both parts to temperature Read More..............
	Soldering Part: brass bellows & end cap for fluid press. regulators Process Temp: 230º c Time to Temp: 7 sec. Notes: Use 50/50 shim perform for soldering; heat 2 joints at same time; controlled heating to avoid annealing bellows Read More..............

	Melting Part: Ferrous and non ferrous Process Temp: 600 - 1650°C Time to Temp: varied. Notes: Ensure feed into melter remains at a constant charge Read More..............
	Case Hardening Part: steel shaft for a clutch Process Temp: 840°C Rate: 20"/min. Notes: Use a single turn induction coil with an integral polymer quench. Read More..............
	Hardening Part: coal picks, wear parts Process Temp: 870°C Time to Temp: <5 sec pending section size. Notes: Provide clearance for the parts to slide through inner diameter of the coil. Read More..............
	Forging Part: Billets or mandrels Process Temp: 1150°C Time to Temp: varying on section size. Notes: Adequate cycle time for heating the product Read More..............
	End Heating Description: mandrel die Temp: 700 - 900°C. Time to Temp: Varying. Notes: Use thermocouple to measure exact temperature. Read More..............